Precautions and details of the use of laser cutting machine

 There are standards and safety regulations for every industry, and the Laser cutting machine industry is no exception. In the process of using laser cutting machines, we often encounter different kinds of problems. Small problems can be  easily solved. However, once there is a serious problem, it will cause immeasurable loss of life and property, so it is necessary to master some details before using the laser cutting machine. For the following Ander laser machine, The manufacturer lists some relevant laser cutting machine precautions and usage details.

1. Comply with the safety operating procedures of general cutting machines. Start the machine in strict accordance with the start procedure.
2. Wear labor protection equipment according to regulations, and must wear protective glasses when near the laser beam.
3. The operator must be trained, familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.
4. Do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.
5. When the equipment is started, the operator shall not leave the post or be taken care of without authorization. If it is necessary to leave, the operator should stop the machine or cut off the power switch.
6. When an abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time.
7. Keep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.
8. Keep the laser, the working bed and the surrounding area clean, orderly, free of oil, and stack the workpieces, plates, and waste materials in order as required.
9.When using gas cylinders, avoid crushing the welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders should follow the gas cylinder supervision regulations. It is forbidden to explode the gas cylinder in the sun or close to the heat source. When opening the bottle valve, operater must stand on the side of the bottle mouth.
10. Observe the high-voltage safety regulations when repairing. When operating every 40 hours or weekly maintenance, every 1000 hours of operation or every six months, the maintenance must be carried out in accordance with the regulations and procedures.
11. After inputting the new part program, it should be trial run first and its operation should be checked.
12. After starting the machine, the machine should be manually started in the X and Y directions at low speed, and check to confirm whether there is any abnormality.
13. When working, pay attention to observe the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective stroke range or two collisions.

Ande Laser Intelligent Equipment (Guangdong) Co., Ltd. is a laser equipment manufacturer integrating R&D, production and sales. Its main products: laser cutting machines, laser marking machines, laser welding machines and laser equipment peripheral automation, etc. ,pls consult us if you have any questions about the laser cutting machine.

     (Some materials on this website come from the Internet. If the information displayed on this website infringes the intellectual property rights or other legal rights of the media or individuals, please notify us in time and we will delete it immediately.)